TEE NUTS

bolts(special bolt lengthen bolt Socket Set bolt high-strength bolt stainless steel bolt).The tee nut is a pressed cylindrical nut with a flat top and sharp prongs jutting 90 degrees down from the fla..

TAPPING SCREWS (SHEET METAL SCREWS)

Tapping screws/sheet metal screws are threaded fasteners with the unique ability to tap their own mating internal thread when driven into preformed holes in metallic and non-metallic materials. Tappin..

TAP BOLTS

Tap Bolts are usually hex head bolts threaded up to the head, with a machined point and a fully threaded shank. Usually of low carbon or grade 5 steel, tap bolts are used in a drilled and tapped hole ..

STRUCTURAL BOLTS

STRUCTURAL BOLTS Used in heavy construction, structural bolts made to ASTM (American Society for Testing Materials) specifications are always used with a nut and often with a hardened washer. The bear..

STOP NUTS (NYLON INSERT LOCKNUTS)

Stopnuts are self-locking nuts, six-sided nuts with nylon-filled collars at their back end. These collars adhere to the thread of the fastener bolt or screw they are being used with. When a bolt or sc..

STEP BOLTS

The step bolt is a carriage bolt with a wide, almost flat, smooth head. It is most commonly used in soft wood applications. The wide head makes it especially resistant to pulling through wood, while i..

SQUARE NUTS

SQUARE NUTS Square nuts are four-sided, internally threaded fasteners, mated with bolts, studs, screws, and other externally threaded products. The addition of the square nut ensures that the bolt, et..

SOCKET HEAD SHOULDER SCREWS

The socket head shoulder screws/stripper bolts (also sometimes called Shoulder Bolts) are ground to very close tolerances, with a thick shoulder usually running 80 percent of the length of the shaft. ..

SOCKET SET SCREWS

Socket set screws are headless and threaded over their entire length. There is a hex or square-shaped socket at the top of the drive in place of a head. Socket set screws come with either cup or knurl..

TAPPING SCREWS-stainless steel screws

Tapping screws/sheet metal screws are threaded fasteners with the unique ability to tap their own mating internal thread when driven into preformed holes in metallic and non-metallic materials. Tappin..