Keps nut

K-nut redirects here. A K-nut can also refer to a Jet nut.A Keps nut, also called a K-nut[1] or washer nut, is a nut with an attached, free-spinning washer. It is used to make assembly more convenient..

NYLON INSERT LOCKNUTS

Stopnuts are self-locking nuts, six-sided nuts with nylon-filled collars at their back end. These collars adhere to the thread of the fastener bolt or screw they are being used with. When a bolt or sc..

SEMS screws

Sems are machine screws and freely-rotating, captive washers manufactured as one assembly. The term Sems is recognized in the US as a generic term applicable to screw and captive washer assemblies, ac..

SELF DRILLING SCREWS

Teks screws, also known as self drilling screws, drill their own hole in thin sheet metal, heavier gauge metals and other materials, then form close mating threads in the hole. The Teks screw is ideal..

PINS-nuts and bolts

There are three primary pin styles offered by InStock Fasteners cotter pins, dowel pins and spring pins.Cotter pins feature a loop at the top where a head may otherwise be. They have a two-part shaft..

PARTICLE BOARD SCREWS

Particle board screws are specialized self-tapping screws with a skinny shank and wide (coarse) threads, both in relation to the width of the shank and the distance between the threads. Particle board..

MACHINE SCREWS

The machine screw is a straight shank part designed to bind metal to metal by going through an opening pre-tapped to form the same configuration as the threads of the machine screw. The thread runs th..

MACHINE BOLT

bolts(special bolt lengthen bolt Socket Set bolt high-strength bolt stainless steel bolt).Hex bolts are bolts with a hexagonal head on one end, with no washer face on the bearing surface, and a thread..

FLAT OR PLAIN WASHERS

Flat washers, also sometimes called plain washers, are used under bolt heads or nuts to increase the bearing area or offer greater hardness, so that the nut or bolt can be rotated without distortion o..

ELEVATOR BOLTS (BELT BOLTS)

Elevator bolts are often used with canvas or other soft, pliable materials. The large diameter, flat countersunk head keeps them from pulling through the material. Also known as belt bolts, elevator b..